



With ears


The below schema only applies to the NG
products
EURO 20 Type 23 PFA10/16 - Reinforced Version
![]() | The EURO 20 type 23:
|
(*) DN350 - Internal bore 300 mm
(**) DN80 - Drilling 8 holes. For drilling 4 holes, please replace the 8th letter of the reference by the letter H.
From DN65 up to 125 there are differences between the square top of the stem on anti-clockwise (ACC) and clockwise (CC) versions.
Material and coating
![]() | |
The below schema only applies to the NG products![]() |
Item | Designation | Material | Coating |
1 | Operating stem | Stainless steel type X2CrNiMo17-12-2 acc. EN10088-3 | - |
2 | Bearing nut | Ductile Iron GS EN GJS 400-15 or 500-7 | EVA (Ethylene Vinyl Acetate) 300 microns mini |
3 | Bush | CuAl10Ni3Fe2 acc. EN12164 | - |
4 | Body | Ductile Iron GS EN GJS 400-15 or 500-7 acc. EN 1563 | Blue Epoxy 300 microns |
5 | Operating nut | CuAl10Ni3Fe2 acc. EN12164 | - |
6 | Gate | Ductile iron acc. EN1563 and EN681-1 selon EN 1563 | EPDM on ductile iron and polyamide brackets |
7 | Bonnet | Ductile Iron GS EN GJS 400-15 or 500-7 acc. EN 15637 | Blue Epoxy 300 microns |
8 | Yoke | Ductile Iron GS EN GJS 400-15 or 500-7 acc. EN 1563 | EVA (Ethylene Vinyl Acetate) 300 microns |
9 | Van O Fra | Chloropren class 60 WA category acc. EN 681-1 | - |
10 | Seal bush | Elastomer Nitrile NBR WRC 70 | - |
11 | Lock washer | Stainless steel 304 or X2CrMoTi18-2 acc. EN 10088 | - |
12 | Yoke-Bonnet- gasket | Nitrile NBR 70 | - |
13 | Bearing bonnet joint | Polyamide type PA 6-6 | - |
14 | Thrust washer | Polyamide type PA 6-6 | - |
15 | Body bonnet gasket | Elastomer EPDM acc. EN681-1 | - |
NF Mark (with flanges in short version S14 and long version S15)
SG Pam is authorized by CSTB to affix the NF Mark on this product (except DN350 and DN400). The product is in compliance with the following complementary standards and specifications:
- NF EN 1074-1 : Valves for water supply – Fitness for purpose requirements and appropriate verification tests – Part 1 : General requirements.
- NF EN 1074-2 : Valves for water supply – Fitness for purpose requirements and appropriate verification tests – Part 2 : Isolating Valves.
- NF 197 : Certification Rules of the NF Mark – Valves – Hydraulic Fountain Fittings.