HUOT 1st Generation adaptation on BLUTOP

HUOT 1st Generation adaptation on BLUTOP

CHOICE OF PRODUCT
Tools
RANGE / MARK ®
® BLUTOP
PRODUCT FAMILY
ACCESSORIES
ACCESSORIES

Manufacturer: HUOT

Address: 2 rue Marsoupe – BP36 – 55300 St Mihiel - Tél : 03.29.91.66.50 – Fax : 03.29.91.20.17

This tool is not manufactured anymore.

Necessary adaptation to work on BLUTOP pipes

Description

References

Adaptation plate 1' Female

YES

220900

Adaptation plate 2' Male (RBA)

YES

220922

Sleeve Std 40 EIE / PAM

YES

220950

Kit of adapters

YES

See SGPAM catalogue

Stem Top M14

YES

220899

BOSCH screw driver without wire (*)

YES

220979

Note :

  • (*) Use the screw driver at the low speed of 400 revolutions per minute on drilling position.
  • To pulverize soapy water on the stem (tool holder) before putting in rotation not to deteriorate the seal of the drilling machine.
DescriptionComplete toolDrill only

BLUTOP tool DN19 for valve 20

214191

215444

BLUTOP tool DN24 for valve 25

214193

215445

BLUTOP tool DN30 for valve 32

214195

215446

BLUTOP tool DN38 for valve 40

214196

215447

This tool will be modified for BLUTOP, only the sealing part will remain.

To offset the screw as shown below To screw the plate 1’ female on the base To screw the sleeve of 40 on the plate 1’ To screw the SGPAM adapter under the sleeve of 40 (see below kit) or

To screw the plate 2' under the sleeve of 40 which will receive your flange adapter

PAM accessories to be used

The rotation of the tool will be made with a screw driver – mandrel of 13 at a speed of about 400 revolutions/minute.

The penetration in rotation into the BLUTOP pipe will be done by a manual support using a screw driver.

SGPAM solution for BLUTOP. Example with AVK kit adapter.

Note: on the sleeve of 40, there is a hole to install a valve of 3/8, not supplied.

Solutions