Technical design
| 80 | C40 | 5 | 40 | SSA80Q60AG-E00 |
| 100 | C40 | 5 | 40 | SSB10Q60AG-E00 |
| 125 | C40 | 5 | 40 | SSB12Q60AG-E00 |
| 150 | C40 | 5 | 40 | SSB15Q60AG-E00 |
| 200 | C40 | 5 | 40 | SSB20Q60AG-E00 |
| 250 | C40 | 5 | 40 | SSB25Q60AG-E00 |
| 300 | C40 | 5 | 40 | SSB30F60AG-E00 |
| 350 | C30 | 4 | 30 | SSB35G60AG-E00 |
| 400 | C30 | 4 | 30 | SSB40G60AG-E00 |
| 450 | C30 | 4 | 30 | SSB45G60AG-E00 |
| 500 | C30 | 4 | 30 | SSB50G60AG-E00 |
| 600 | C30 | 4 | 30 | SSB60G60AG-E00 |
| 700 | C25 | 4 | 25 | SSB70H60AG-E00 |
| 800 | C25 | 4 | 25 | SSB80H70AG-E00 |
| 900 | C25 | 4 | 25 | SSB90H70AG-E00 |
| 1000 | C25 | 4 | 25 | SSC10H70AG-E00 |
Features
- DN60 to 300 : Reference pipe + joint + Elastomer Sleeve
- DN350 to 700 : Reference pipe + joint + Heat-shrink Collar
- DN≥800 : Reference pipe + joint only. Don't forget to add roll of 30m Heat-shrink Collar and box of 25 Closing sleeve. Quantity to be determined depending on the project.
Documents
The STANDARD gasket is compatible with the whole STANDARD sockets for pipes and fittings from water and irrigation ranges.
The STANDARD gasket is a push-on joint. The watertightness is made by the compression of the elastomer gasket which operates during the assembling by the introduction of the spigot end inside the socket.
The installation must be done in a clean and dry environment.
Necessary equipment to install the aluminium sleeve
- Aluminium adhesive tape width 75mm
- Tool (in wood) for the completions
- Gas-burner
Protection of joints of pipes and fittings DN60 to 300 for TT PE and TT PUX
Warning: in the case of pipes with anchored joints (Standard Vi, Universal Vi or Ve, Pamlock, Standard Ve) in salted area, the elastomer sleeve must be replaced by the heat-shrink collar.
,
Protection of joints of pipes and fittings DN80 to 700
Protection of joints of pipes and fittings DN150 to 2000